We size every Beaverton, OR system to basin capacity and inflow rate, not a generic package.
Drain tile that isn't sloped correctly is one of the most common installation failures we see when repairing someone else's prior work — water simply pools instead of flowing to the basin. We verify slope with a level, not by eye.
We're licensed and insured for residential and light commercial interior drainage work across Beaverton, OR.
Interior drainage installs are scheduled locally, without routing through a national call center that adds weeks to the timeline.
Pricing is based on linear footage of drain tile needed, quoted in writing after an in-person measurement.
Drain tile that isn't sloped correctly simply won't move water — we verify slope with a level during installation, not just by eye.
We scope every Interior Drainage System job in person before quoting it, since two properties with the same symptom rarely need the same fix.
A channel is cut along the slab edge, perforated pipe is laid with proper slope, and gravel backfill allows water to flow freely into the drain.
Every interior drain system needs a sump basin as its endpoint — we size the basin and pump to match the drain tile's expected inflow.
For finished basements where cutting the slab isn't practical, a baseboard channel system captures wall seepage without disturbing existing flooring.
We treat the cove joint as part of every interior drainage install, not as a separate add-on.
Existing drain tile that's clogged with silt or has failed slope can often be cleaned or repaired rather than fully replaced.
This helps us bring the right materials and estimate linear footage before the visit.
A technician checks where water is entering, measures the perimeter, and identifies the best sump basin location for discharge.
We explain why we're recommending full perimeter versus targeted sections based on what the inspection found.
We test the system with water flow before finishing to confirm proper slope and basin performance.
"Old drain tile from the 1970s had completely silted up. They cleaned what could be saved and replaced the rest."
— Beaverton Homeowner
"Finished basement meant we couldn't cut the slab easily. Baseboard channel system worked great as an alternative."
— Beaverton Customer
"They tested the system with a hose before calling it done, which gave us confidence it would actually work in a real storm."
— Beaverton Homeowner
"Clean install, patched concrete matched the existing floor color almost perfectly."
— Beaverton Customer
Not always — if water is only entering along one wall, a targeted section can be enough, which we determine from inspection findings.
We'll recommend whichever fits your basement's finish level and budget.
{Sometimes — if the pipe itself is intact but clogged with silt, cleaning can restore function without a full re-installation.|We camera-inspect where accessible to make that determination before recommending replacement.}
Basin size is based on expected water inflow from the drain tile's linear footage and your Beaverton, OR area's typical rainfall intensity.
If disruption is a major concern, we can discuss the baseboard channel alternative instead.
Most residential installs finish in one to three days depending on perimeter length and whether cove joint sealing is included.
Not sure if your basement needs full perimeter drain tile or a targeted fix? Call +1-866-476-1348 and we'll walk through it.
Zip codes we serve in Beaverton, OR: 97006 97225 97003 97005 97007 97008 97075 97076 97077 97079 97078
Call now for a free inspection and a flat-rate quote before anything gets worse.
Call +1-866-476-1348© SGP Waterproofing. All rights reserved.
